Sign up for our emails to get 10% off your first order. We'll also keep you updated on new products, exclusive collabs and promos.
By providing your email, you agree to receive recurring automated marketing emails from this shop.
Draft Beer Fittings
105 products
Showing 1 - 24 of 105 products
Draft Beer Fittings & Replacement Parts – All Types & Sizes
This is the small-hardware backbone of a draft system — the fittings, barbs, splices, clamps, and tailpieces that connect beer line, CO2 line, and glycol hose to everything else. If you're troubleshooting a leak, replacing a worn part, or building a kegerator from scratch, this is where the connectors live.
Barb Fittings – For securing beer line and gas tubing to couplers, faucets, and regulators
MFL Flare Fittings – Standard male flare lock fittings for CO2 and gas line connections
Threaded Connectors – NPT and BSP threaded fittings for gas and liquid applications
Glycol Hose Fittings – Compatible with polyethylene and barrier glycol tubing
Clamps & Crimpers – Stepless Oetiker clamps, worm-drive screw clamps, and the crimping tools to install them
Splices, Tees & Y-Bends – For joining, branching, or reducing line size mid-run
Matching Fitting Size to Your Line
Fittings are sized by barb OD to match your tubing's ID — a 3/8" barb fitting is for 3/8" ID beer line, not 3/8" tubing OD. If you're not sure what size line you have, measure the inside diameter where it slides over a barb, or check the spec sheet for your coupler, faucet, or shank.
Looking for something else?
Not every kegerator or draft system part lives in this collection. If you need:
Not sure which part you need? Contact us with what's happening (leak, wrong size, replacing a broken part) and we'll help you find the exact fitting — no guessing, no ordering the wrong thing twice.
Fittings FAQ
How do I know what size fitting I need?
Match the fitting's barb size to your tubing's inside diameter (ID), not the outside diameter. If you're replacing an existing fitting, measure the old one or check the tubing spec; if you're not sure, send us a photo or the tubing size printed on the line and we'll confirm before you order.
Barbed fitting or compression fitting — what's the difference?
A barbed fitting pushes into the tubing and relies on a clamp to hold the seal — the standard for beer and gas line. A compression fitting uses a nut and ferrule to grip the tubing without a separate clamp, common on rigid or semi-rigid tubing and some CO2 connections. Use whichever your existing line and coupler are already set up for; mixing types usually means replacing more than just the fitting.
Do I need stainless steel fittings, or is brass or plastic fine?
Stainless steel is the standard for commercial draft systems — it resists corrosion from beer, CO2, and cleaning chemicals over years of daily use. Brass and plastic fittings show up in lower-cost or home kegerator kits, but for a bar or restaurant running daily cleaning cycles, stainless is worth the extra cost.
What's a hose splice or a Y-bend actually used for?
A splice joins two lengths of the same-size tubing into one continuous run, or steps between two different sizes. A Y-bend (or tee) branches a single line into two — common when running one CO2 supply to multiple regulators or splitting a cleaning line to reach two faucets at once.
