Wrench For Co2 & N2 Regulators - 1/8" Hex, Offset, Closed End

Always Ready When You Run Out of Gas

Nothing kills a pour faster than a dead CO2 tank and a missing wrench. The Taprite Regulator Wrench stays on your regulator so you're never scrambling when it's time to swap tanks — just grab, turn, and you're back to serving.

Why Bar Pros Keep This on Their Regulator

• 1/8" hex offset closed-end design fits CO2 and N2 regulator fittings precisely
• Leave it on the regulator permanently — no hunting for tools mid-service
• Compact and low-profile; won't snag on lines or equipment
• Built by Taprite, the industry standard in draft beer gas hardware

Fits Your Setup

Compatible with standard CO2 and N2 regulators used in bar, restaurant, and brewery draft systems. A simple addition that eliminates a surprisingly common headache.