Surface Mount Stainless Steel Drip Trays — No Cutting Required
Surface mount drip trays sit directly on top of the bar or counter beneath your draft faucets. No cutout, no routing, no carpentry — just set it in place, connect the drain, and you're done. They're the fastest way to add a professional drip tray to any draft setup, and the right choice for retrofits, kegerators, and temporary or rental bar builds.
Features
304 stainless steel construction — commercial-grade, corrosion-resistant, easy to sanitize
Drain hole included — standard fitting connects to bar waste drain or bucket
Removable grate — keeps glasses elevated above standing liquid; lifts out for cleaning
Low-profile design — sits flush against the bar front without obstructing the pour
Available Widths
Single-tap through multi-tap widths in stock
Width is measured center-to-center across your faucet shanks — measure before ordering
Allow at least 3–4 inches per tap for comfortable glass placement
Installation
Surface mount trays require no tools to install. Position beneath your faucets, connect the drain fitting to your bar waste line or a drip bucket, and secure with the included hardware if desired. Most installs take under 10 minutes.
Does a surface mount tray need to be plumbed to a drain?
Not necessarily — you can connect the drain fitting to a bar waste line for a hands-off setup, or run it to a bucket underneath and empty it periodically if plumbing isn't practical. Both are common depending on the install.
How do I measure for the right width?
Measure center-to-center across your faucet shanks, then add roughly 3-4 inches of tray width per tap for comfortable glass placement on either end. Round up if you're between sizes.
