Sign up for our emails to get 10% off your first order. We'll also keep you updated on new products, exclusive collabs and promos.
By providing your email, you agree to receive recurring automated marketing emails from this shop.
Draft Beer Hose & Tubing
42 products
Showing 25 - 42 of 42 products
Beer Line, Gas Line & Glycol Hose for Draft System Builds and Repairs
The right hose makes the difference between a clean pour and a service call. We stock every type of draft beer tubing used in commercial installations — sold by the foot so you order exactly what you need, no waste.
Tubing Types
Vinyl beer line — 3/16" and 1/4" ID; standard for direct draw and kegerator applications
Barrier beer line (Bev-Seal Ultra) — BA-approved for long draw trunk bundles; blocks CO2 loss and O2 permeation
Braided vinyl — higher burst strength for jumper lines and short-run pressure applications
Polyethylene glycol hose — for glycol supply and return lines in long draw cooling systems
Gas line tubing — CO2 and nitrogen rated; compatible with standard barbed fittings
Sold by the Foot
All tubing is available in cut lengths. Order the exact footage your build requires — no minimum, no leftover coils. Bulk rolls also available for high-volume installers.
Choosing the Right Tubing
Direct draw / kegerator: 3/16" vinyl beer line
Long draw trunk bundle: barrier beer line (required by BA guidelines)
Jumper lines: braided vinyl or barrier, depending on run length
Glycol system: polyethylene glycol hose matched to your power pack spec
Tubing FAQ
Do I need barrier tubing, or is standard vinyl beer line enough?
Standard vinyl is fine for short direct-draw runs under a kegerator. Barrier tubing is required by Brewers Association guidelines for long draw trunk bundles because it blocks CO2 loss and oxygen pickup over distance — standard vinyl will let both leak through on a longer run, flattening the beer.
What size beer line ID should I order?
3/16" is the standard for most direct-draw kegerator setups. Longer runs typically move up to 1/4" or 5/16" to reduce resistance, but the right size also depends on your regulator pressure and desired pour speed — if you're building a long draw system, spec the ID against your run length rather than guessing.
